That's not a header....This is a header

[rucrzy]

woo.the header look like those header for turbo setup!

[supernatural]

looks nice.. wats the cost of the header?? and when are u planning to dyno it??

[STEVtEc]

looks very nice, but does it perform? have you had other aftermarket headers on your car prior, to compare?

[Edw-R]

Amazing. It seems a turbo set-up. 3" collector. Are you using 3" cat and cat-back too?

[hebe]

I think his car is turbo? I saw a FS thread on CRSX on his turbo setup? Unless if that is a different White R ...

[eg5]

Amazing. It seems a turbo set-up. 3" collector. Are you using 3" cat and cat-back too?

Allmotor set up
3 inch metal cat
3 inch cat back

[BlackDC2]

looks very nice, but does it perform? have you had other aftermarket headers on your car prior, to compare?

see below

No difference in power with the current setup but, fingers crossed, it works wonders with the new combo.

[z10]

The fan is a temporary fix while a higher flowing, better fitting fan is sourced. We cut the shroud roughly and let the header do the rest.

The car has Hasport mounts - so it doesn't move much Clearance is more than it looks in the picture.

As far as coating goes, I'm going to see how i go with temps on Thursday. It should be ok though.



Yup, Burns collectors - unbelievable work, shame I never took any pictures of them.

i did

[sangers]

how much was it? apparently k series engines respond well to larger exhausts as well, even without boosting. i wouldn't mind getting a 3" straight through exhaust

[rG`]

Impressive workmanship

With 3" D, I can see your top end improving (but at a cost of low-range rpms?). Hoping the latter won't be the case and looking forward to graphs & review.

[WhiteDC2]

looks nice.. wats the cost of the header?? and when are u planning to dyno it??

looks very nice, but does it perform? have you had other aftermarket headers on your car prior, to compare?

Dyno will be done when the new motor goes in, which is hopefully within the next couple of months. I stress that this header isn't for the current setup and I'm aware that it's too big for this motor. The header has been matched to the new motor, so hopefully it works out and we get a decent figure.

[Danga]

This header is even more amazing in real life... truly a work of art

You should hear the exhaust with the BUNG in LOL!

[dang]

fark that's PIMP! Loving it.

[J-MuN]

Phwoooooar!!

[tofuR]

troy .. i cant stop looking at these pics of your header.. what a beauty she is =p

all the right curves in all the right places =)