Innovative Mounts

[plAythiNG]

Hey guys, i'm ordering the Innovative Mounts; in Billet Alloy replacements in 60A (red) Street Urethane stiffness

Just wanted to know how much roughly its going to cost for it to be put in.

[ChargeR]

If I were a mechanic I would aim to do it in 1.5-2.5 hours roughly. So multiply that by your workshop of choice's hourly rate and you should have a good idea of what it will cost. Have you considered getting the steel mounts, they are cheaper and seem to have less fitment issues.

[plAythiNG]

Well, i thought if i was to do something, do it irght, first time. Aren't the billet Alloy mounts alot stronger?

[TypeSexy]

im getting mine from shift soon, have to install myself it shouldn't be too hard ill write up a DIY on it as well

[plAythiNG]

How hard u reckon it is mate? I htought it was quite a tough process, i mean it is hoolding in your engine lol

[TypeSexy]

you do it one by one

and you leave your jack under your engine for support

basically removing the bolts, putting your new one in and moving the jack up and down to align the holes for the bolts.

the rear mount is a bit harder as you have to disconnect the header (i think) to get to it.

[plAythiNG]

Hmmm, so its a quite a hard process, i htink i'll leave it 2 top one.

[ChargeR]

Well, i thought if i was to do something, do it irght, first time. Aren't the billet Alloy mounts alot stronger?

A lot of aluminium alloys have a better strength to weight ratio than common steels but depending on the design of the mounts the steel ones may be stiffer and stronger. The polyurethane inserts are most likely the weak point of the design anyway, and you will never break a mount unless you have 26" slicks and 800 hp.

[plAythiNG]

OK, well my car will never have an anrmous amount of power... engine mdos.... if i ever get anything will only be some type of nitake manifold and kpro.

Should i get the steel or billet Charger?

[TypeSexy]

which one are you getting

[plAythiNG]

I was gonna get the street ones (red)

I jsut called up TOP ONE.

he said to not get the innovative... for isntalllation, he said u have to cut and modify the paassenger one.. Im going hasport.

[TypeSexy]

doubt it man, i read about them and no need for cutting its just remove old one and put the new one in

[plAythiNG]

hmm, hasport is qutie more expensive too ey

[ChargeR]

I have the steel Innovative mounts with grey 85A hardness bushes. Install went off without a hitch and I have had no problems with them. If you prefer the engine bay bling of the billet model then get them, but that and a possible slight weight difference is the only advantage the billet ones have over the steel.

[TypeSexy]

hmm, hasport is qutie more expensive too ey

can try ebay but it comes to like 40 dollars off the trader's price.

but if you have a problem its easier to go to the trader and get them replaced then going to ebay again