Announcement

Collapse
No announcement yet.

DIY: Tighten Handbrake

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    DIY: Tighten Handbrake

    Anyone know how??
    or where i can get it done cheaply?
    My handbrake barely works.. I pull it 95% up and the car still moves.
    i live in sydney, hills district.
    Last edited by fezp; 03-04-08, 05:37 PM.

    #2
    ha ha, painful task if its a DC5...

    Take off the large panel around the handbrake.

    For a good guide, google BuddyClub short shifter install.

    There should be an adjuster at the back of the ratchet.

    Go to a Honda dealer and they will jack you for the money and not do it because they are soo lazy, then tell you that they adjusted it as far as it will go.

    Its a bitch, seriously, I hate doing it because there are so many interior panel clips that can break and so many things you can scratch.

    Do it then get drunk to ease the stress lol

    Comment


      #3
      Originally posted by fezp View Post
      Anyone know how??
      or where i can get it done cheaply?
      My handbrake barely works.. I pull it 95% up and the car still moves.
      i live in sydney, hills district.
      y0! what car do u have?
      ... retired/

      Comment


        #4
        Dc2r

        Comment


          #5
          do not over tighten the handbrake cable. Some noob who had the car b4 me over tightened it and has screwed my rear brakes (the spring that engages/disengages rear brakes is stretched and it grabs until the rear pads are warn down 1m or so)

          so yer, check your rear pads if there is much pad left....
          RWD + Boost =

          Comment


            #6
            1. Pull off hand brake centre cover
            2. You will see two parallel cables running to the rear of the handbrake with an adjustable bolt
            3. Apply hand brake very slightly (only one click)
            4. Jack up rear wheels (but place bricks or wedge something to stop the car rolling forward)
            5. Spin either wheel (in your case there will be little resistance even with the hand brake up).
            6. Adjust bolt by screwing clockwise (off memory) and try spinning the wheels. Keep adjusting until there is resistance to the wheel spinning.
            7. Apply hand brake as you usually would
            8. Try spinning the wheels again & they shouldn't budge.
            9. Grab a beer.
            j0nbubz: RG's awp is LOL
            Chi: ...word of advice on who plays against rG
            faijai: rg + awp = gg
            hebe: Hahaha rG is just L337 bro!
            rG`: Touchpad FTW!

            Comment


              #7
              Disclaimer: The above post is meant as a guide only, no responsibility accepted for loss or damage sustained.

              :P
              j0nbubz: RG's awp is LOL
              Chi: ...word of advice on who plays against rG
              faijai: rg + awp = gg
              hebe: Hahaha rG is just L337 bro!
              rG`: Touchpad FTW!

              Comment


                #8
                hahah thanks.
                i might give that a shot tomorrow if i feel confident enough.

                OOO i dont think i got a jack with my car.. might hav to go buy one.. =S

                Comment

                Working...
                X