If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
i received some DIY instructions from that RSX-CT (Todd) guy cos i was going to do the retrofit myself for DC5....parts were going to be expensive, (TSX projectors)
and i dont have time to do it...thats the other problem!
could u post the instructions or send them to us and also list the parts? are they for 02-04 lights or 05+?
Freakygeek was that photo you posted only with one projector?
Post photos of both lights on High Beam !
This photo? Yes, this is the output from ONE projector on LOW beam!
| 1991 Formula Red NSX | 1999 CW DC2R #00-193 | 2013 Black CBR1000RR
"And so you touch this limit, something happens and you suddenly can go a little bit further. With your mind power, your determination, your instinct, and the experience as well, you can fly very high." - Ayrton Senna
DIY instructions dont come with pictures tho...so i dont know if you want it, but i can go dig it up. on the other hand, i found this too... www.TheRetrofitSource.com
they sell their products on ebay, have a forum, DIY guides, loads of stuff
FFA
=D
also, as far as im concerned, u can use any projectors u want...u just have to cut...
and obviously get the bulbs to match the projectors, so d2s or d2r etc etc
ballast etc.
then u can decide on what kinda shroud u want or bezel or both..and away you go!
the DIY section in the above website has a list of tools u need for a DIY as well, so tahts good
Comment