My DC2R with JDM conversion

[Karl]

Mod's
Exterior:
Jdm front conversion" Includes hid light's, Floods lights "

Very dark window tint

Brakes:
DBA 4000 Slotted front
RDA Slotted rear
Ferodo DS2500 pad F and R
Goodridge Braided brakes lines
Motul RBF600 brake fluid

Handling:
Tegwia X brace
Ultra racing 3 point front strut bar
Buddyclub Rear Camber Kit
Tire's Front RS3s 225/45/15 -- Rear Kumho KU36s 205/50/15
SSR Type C, Rays Volk TE37

Interior:
JL's 6" Back speakers only
Pioneer high end deck
Rear wiper and motor removed
Removed antenna and motor. Installed windscreen antenna
Water temp, Air/fuel ratio in custom dash cluster
Oil pressure, oil temp in custom Clockpod
No rear seats or interior behind driver seats

Performance:
Earthing kit
Koyo R series radiator
2 x 10" Davies Crag fans
Ram,Cai with K&N pod in stock box
Dc sport 2.5" Header's, Heat wrapped
Highflow cat
J's racing full stainless steel Catback
Hasport engine mounts
Moroso baffled oil pan
Apexi neo tuned at 128.8 KW ATW, vtec engagement point - 5000rpm

Plan's
Front camber kit
Coil overs
Oil cooler


[ATTACH]4175[/ATTACH]

[ATTACH]4176[/ATTACH]

[tinkerbell]

looks pretty clean

original paint job?

i do love the red with white socks look

[aidannn]

did u buy this from felix?

[Karl]

Um Felix. I dunno he lived in chatswood and was Asian. Can't recall his name.. Yer the car was resprayed by previous owner... Ownly had car for about 2 months now.. It is my second DC2 R.. 1st one sold for work... Just love them

[Karl]

Back side

Sub Amp

Engine bay

[Karl]

Thinking what you guys think??

[itrboy]

i saw this car outside top one a while back and it looked superrr clean inside and out looks like a good buy its so hard to find a dc2r thats been well loooked after these days...and i love the jdm front and wheels!

[tiah313]

clean engine bay, just need more lowz

[Karl]

Yer the past owner used to have it serviced at top one. Yer really happy with it. Runs better then my last DC2R. I find that with the conversion the front sits abit lower to the road. Wont be lowering it. Struggle getting up and down my drive way as it is. Next plan is straight through exhaust with header's, want to keep the noise on the low though. Any recommendations of a good exhaust place around Sydney??

[markR]

if you want noise levels at a minimum, many people including myself would suggest
mugen twinloop
fujitsubo rm01a
if you wanted an off the shelf system.

personally, i'd recommend performance exhaust in north parramatta.
haks can make any exhaust o suit your needs.

[Karl]

North parra. Just down the road. I'll go and check them out! thanks Mark

[Karl]

Looked into the twinloop exhaust.. Isn't that restricting the air by looping like that???

[AsHw3e]

digging the car dude, very nice and clean love looking at the jdm dc2r's

[Karl]

Thanks mate

[Karl]

Made new boot base. And Sat 12 inch sub in spare wheel. Made from 12 mm MDF. Took 3 hr's in total. And cost 40 bucks for MDF and carpet.