[FN2R] Gruppe M Ram Air Intake

[Tiu]

I have purchased my first mod for my FN2R, Gruppe M Intake! :thumb: however, i had something that i wanna DIY for the intake. The carbon scoop that guide air into the airbox when the bonnet's down.

However, in the photo below you can see the left side of the carbon scoop has quite a bit of gap, causing the air are not guided to the airbox effectively :shifty: what could i use to stuff that gap to prevent air from escaping on the left side of the scoop.

[MrThanh]

you're supposed to cut the OEM hoodliner. I'd also advise you to put the sensor on the underside so that it doesn't scratch your inlet duct.

[Tiu]

so after cutting the OEM hoodliner, it meant to just cover the gap?

[MrThanh]

it covers half of the bonnet from the left up to the carbon duct.

i'm pretty sure there's an image with instructions on the installation guide that shows how to cut it.