Axle back muffler rubbing against my swaybar

[3r1k]

Guys got a small problem here where there is barely any space between my axleback and my swaybar (JDM DC5R).

It always rattle against each other when I start the car and when I turn left going uphill.

What can I do??

Erik

[JustDC5R]

change rubber holders for muffler?

[3r1k]

Mmmmm , I'll drop super cheap auto today and check it out.

Can you DIY it? Is it hard to remove the existing rubber and change it to a new one?

[CK1]

this might not work, but u can always try pulling ur pants down....... hehe

[sifoo]

Go to an auto store and buy a radiator or coolant hose and wrap it around your sway. Works perfectly on mine, hasnt burned through at all.

[3r1k]

Update:

Did some adjustment to it and the clearances is still limited to 1 cm or so, Couldn't get more out of it, I guess I have to wrapped my exhaust then

[Dny]

wrap the swaybar

[air23box]

yeah....wrap the sway erik....not the exhaust.....lol...

[3r1k]

LOL ups :P my bad.

We know who is noob here :P

I'll get this sort out asap

[RDC-5™]

Sell your jdm rear sway and get an aftermarket one, like mugen or cusco. My rear sway gives a 2cm clearance from the same axle back your using.

[Chi]

lol wrap exhuast

Maybe this might help too?

http://cgi.ebay.com.au/VISION-EXHAUS...QQcmdZViewItem

[ChargeR]

Sell your jdm rear sway and get an aftermarket one, like mugen or cusco. My rear sway gives a 2cm clearance from the same axle back your using.

Hmm thats interesting because I have the JDM rear sway and the same exhaust () and I have at least 2 cm clearance as well. I would be looking at the exhaust rubbers or something, maybe get shorter ones to raise the exhaust up?

[TODA AU]

Guys got a small problem here where there is barely any space between my axleback and my swaybar (JDM DC5R).

It always rattle against each other when I start the car and when I turn left going uphill.

What can I do??

Erik

It's probably installed back to front.
Take it off, turn it round 180deg & refit.
See how that goes

[3r1k]

Ok let me give you guys the long story.

I fit my exhaust and toda header which caused the whole system sat to low then I sent my car to a shop to get the whole system raise by modifying the flex pipe of my toda header.

When the exhaust system was low, I DID NOT have this problem at all.

Any clue? If there is no solution at all, I will just get radiator hose and wrap it around my swaybar.

Thanx for the help guys.

[TODA AU]

Ok let me give you guys the long story.

I fit my exhaust and toda header which caused the whole system sat to low then I sent my car to a shop to get the whole system raise by modifying the flex pipe of my toda header.

When the exhaust system was low, I DID NOT have this problem at all.

Any clue? If there is no solution at all, I will just get radiator hose and wrap it around my swaybar.

Thanx for the help guys.

LOL, OK....